4
−−−−
sec. new 2009
2GO! - Technical manual
ne
W
TONE SELECTION
Five tones can be selected on 2GO! system indoor stations. The tones
can be programmed also by the end user by following the simple
sequence below.
DOOR PHONE CALL TONE
Five tones can be selected on 2GO! system indoor stations. The tones
can be programmed also by the end user by following the simple
sequence below:
1. Hold the door opener button
pressed. Press and release the
button. The indoor station will play a tone.
2. Hold the door opener button
pressed and press the button
again to change the tone.
3. Release the door opener button
when you have chosen the
tone you want. The tone is now programmed.
FLOOR CALL TONE
Five
fl
oor call tones can be selected on 2GO! system indoor stations.
The tones can be programmed also by the end user by following the
simple sequence below:
1. Hold the door opener button
pressed. Press and release the
button
. The indoor station will play a tone.
2. Hold the door opener button
pressed and press the button
again to change the tone.
3. Release the door opener button
when you have chosen the
tone you want. The tone is now programmed.
PROGRAMMING DATA DELETION (RESTORE
DEFAULT SETTINGS)
Proceed as follows to delete all optional programming data:
1. Holding button pressed, press button . The video door
phone will beep twice to indicate that it is in programming mode.
Button
will start blinking red.
2. Press
and
at the same time for 3 seconds until you hear the
deletion tone.
3. Press the apartment station button
. The video door phone will
beep when you exit programming. Button
will go out.
IMAGO HANDS-FREE COLOUR TFT 4” VIDEO DOOR PHONE Ref. 1707/1
TONE SELECTION
CONTRAST, BRIGHTNESS, COLOUR ADJUSTMENT
IMAGO HANDS-FREE COLOUR TFT 4” VIDEO DOOR PHONE
Ref. 1707/1
CONTRAST, BRIGHTNESS, COLOUR
ADJUSTMENT
These video parameters can be adjusted only when the video door
phone is on, after receiving a call or selecting the auto-on function.
Use the joystick button (2) to access the setting menu.
Press the right button (4) to increase and the left button (3) to
decrease.
Press the
SELECT
(5) to go to the next parameter in the following
sequence:
contrast
exit
OSD menu
brightness
colour
reset
The
RESET
is used to return all parameters to the initial condition.
Press either the right or the left button of the joystick to reset the
parameters. Press the middle button to exit the setting menu.
The changes will not be stored if the video door phone goes out
before exiting setting mode.
•
•
•
