urmet domus 1375/701, Installation Booklet

Page: 7 / 12

7
DS1375-033A
INSTALLATION OF THE DEVICE
The switch Ref. 1375/701 can be installed on the table by inserting the appropriate rubber feet on the base
of the device, or on the wall using the screws and anchor plugs provided, see below.
Two self-threading screws,
Ø 3.5 x 16 mm included
Two anchor plugs Ø 5 mm
LED OPERATING STATE AND BUTTONS
POWER LED
On green Switch powered and on
Off Switch not powered
LED PoE MAX
Red on The power output to the devices is higher than 57W
Red flashing for 5
seconds
A device has been disconnected from a PoE port but the port continues to deliver
power
Off The power output to the devices is lower than 57W
PoE LED INDICATION ON PORTS
On green A PoE powered device is connected to the port and powered correctly
On amber
One of the following problems which do not allow powering through the port is
present:
• the required power exceeds the available limit
• short-circuit on line
Off No device with PoE power supply connected to the port
LAN LED INDICATION ON PORTS
On green Data transmission/reception at 1000 Mbit/s
On amber Data transmission/reception at 10/100 Mbit/s
Off No connection
REBOOT BUTTON
Pressure less than 4 seconds The system will be rebooted
WARNING! Do not press the reboot button for more than 4 seconds, otherwise the device will
reset to default settings and lose the set configuration that allows the iPerTAlk system
to integrate with the Ipercom system. In this case, contact the URMET Technical
Assistance Centre directly to have the configuration of the device restored.
LAN PoE