Use the following procedure to enter a new Door Open Code or change the existing Door Open
Code -
Press
then enter the Engineer’s Password and press
(BEEP BEEP BEEP).
Press
again (BEEP BEEP BEEP).
Enter the relay time (door open time). E.g. for 5 seconds press
5
or for 10 seconds press
10
(
BEEP BEEP BEEP).
Enter your chosen Door Open Code (3 to 8 digits) then press
(
BEEP BEEP BEEP).
Press and hold
until you hear a long BEEP.
Tel 01376 556010
www.urmet.co.uk
[email protected]
Page 2
Under certain circumstances (power cuts, supply voltage spikes etc) the keypad will enter a
protected mode whereby the Door Open Code will not work, but instead pressing
will open
the door.
In this case the keypad will need to be reset –
Remove the power from the keypad.
Press and hold the PASSWORD KEY (see Page 1).
Re-connect the power while holding the PASSWORD KEY.
Continue to hold the PASSWORD KEY until three beeps are heard.
Release the PASSWORD KEY.
Program the keypad as per Page 1.
