15
is now ready for use.
Function test:
Perform a function test of the device for
each paired Transmitter
as follows:
•
Press the "pairing button" on the Transmitter. For as long as you hold the button,
the two LED displays light up on the Receiver (orange - drop icon and Red -
battery icon) of the radio channel to which the Transmitter was paired.
Transmitter and Receiver are connected to this channel. Please keep in mind
that it may take about 1-2 seconds when you press the pairing button until the
LEDs are lit. This is due to the fact that the Transmitter, in order to save power,
communicates with the Receiver in a pulsed mode.
•
Bridge over both Transmitter buttons (fig. 4) with a coin (or any other electrically
conductive object) and firmly hold the coin on the press studs so that a
permanent electrical conductivity is provided.
•
An increasingly loud alarm signal will sound.
•
The LED display for the Transmitter (fig. 5) "orange - drop symbol" (alarm off)
lights up in the Receiver.
•
Remove the coin from the press studs.
•
The alarm signal continues until the alarm is switched off.
•
On the receiver, press the "alarm stop" button. (Fig. 5)
•
The alarm signal stops. The orange Display for the Transmitter LED goes out.
