14
3.1 Source Port
Scroll to select “3.
1 Source Port”, then press “OK” to copy to and verify targets from the
source port.
3.2 Internal Storage
(Available when internal SSD is installed)
Scroll to select “3.
2 Internal Storage” , then press “OK” to select which GOB Image to copy
and verify from the duplicator’s built-in storage device. The GOB Image is created through
U-Reach’s proprietary software that is included with the duplicator.
4. Erase
There are 4 submenu modes.
Step 1: Connect device(s) for sanitizing.
Step 2: Enter function “4. Erase”
Scroll to select “4. Erase”, then press “OK” to view the 6 submenus.
4.1 Quick Erase
This function will erase the index table from the connected device(s).
Scroll to select “4.1 Quick Erase”, then press “OK” to start the erasing process.
4.2 Full Erase
This function will erase all data per NIST 800-88 Standards to the connected device(s).
Scroll to select “4.2 Full Erase”, then press “OK” to start the erasing process.
Caution
1. When “1.2 Internal Storage” is selected, the 1
st
port becomes a target port
automatically (e.g. NV-BM60 will become 1-6 duplicator). Please use the
duplicator carefully as the manufacturer will not held responsible for any data
loss.
2. The GOB Image (internal storage) will not copy to smaller target capacities.
Caution
Please backup all important data before using this function.
Note
Source Port is disabled for erasing. Go to
6.6 Advanced Setup
, scroll to select
Erase Master
function to enable source port erasing.
