1. Press POWER to power on the detector.
2. Follow the instructions described in OPERATION to set SENSITIVITY,
VOLUME and operation mode.
3. Place the detector on a wooden or plastic table, then remove any
watches, rings, or metal jewelry you are wearing.
4. Adjust the search coil so the flat part points towards the ceiling.
Note:
Never test the detector on a floor inside a building. Most buildings have
metal of some kind in the floor, which might interfere with the objects you’re
testing or mask the signal completely.
5.
Slowly sweep a sample of the material you want the detector to find
(such as a gold ring or a coin) 2-3 inches or more above the face of the
search coil. When the detector detects any metal, it sounds a tone and
an arrow appears below the target icon. Also LCD displays the depth of
the target.
Note:
If you are using a coin, the detector will detect it more easily if you hold it so
a flat side is parallel with the flat side of the search coil. A sweep with the
side of coin over search coil might cause false indication and unstable
display of arrow.
Outdoor Testing and Use
1. Press POWER to power on the detector.
2. Follow the instructions described in OPERATION to set SENSITIVITY,
VOLUME and operation mode.
3. Find an area on the ground outside where there is no metal.
4. Place a sample of the material you want the detector to find (such as a
gold ring or a coin) on the ground.
Note:
If you are using valuable metal such as gold to test the detector, mark the
8
