21
C100 Installing
Network Installation
The C100 Hub can be installed using a Wi-Fi wireless Ethernet
connection or via traditional hard-wired Ethernet connection.
When installing the hub for the first time, your installer must
perform one of the two following steps:
●
Connect the hub to your wireless access point by using the
WPS button on the hub, and the one on the wireless access
point. When successfully connected to the wireless access
point, the Wi-Fi LED on the hub will glow either blue, green,
yellow or red, based on Wi-Fi signal strength. Setup is now
complete. If you wish to set specific network settings, see
section below.
Or
●
Connect the hub to the local Ethernet network via a wired
Ethernet connection.
