Safety & Precautions
Please read this manual thoroughly before attempting
to install or operate your URBARN™ horticultural light,
and keep it in a safe place for future reference. This
fixture must be installed by a qualified electrician.
It is important that you read, fully understand, and
observe the subsequent safety precautions.
This fixture is suitable and rated for damp and dry
locations. Care should be taken that it is used in a
manner that does not exceed its rated ampacity or the
maximum ambient temperature (40°C) of its installed
environment. For longevity and peak performance,
avoid exposure to direct sunlight as it may raise
ambient temperatures past the fixture rating.
The URBARN luminaire should not be concealed
or extended through a wall, floor, ceiling, or other
parts of a building. It should not be located above a
suspended ceiling or dropped ceiling, and should not
be permanently affixed to a building structure.
Care should be taken that the luminaire mounting
components and wiring are not subject to strain and
are protected from physical damage. When suspended,
each luminaire should be visible over its entire length.
While our URBARN fixture operates at a low
temperature, it is best not to touch while in operation.
Connect your URBARN light fixture to power sources
of the correct voltage. Protect power cables from
being pinched, walked on, or otherwise damaged.
Be especially careful where the power cable enters
the housing of the unit. Only connect the light to an
electrical outlet or extension cord of appropriate type
and rating.
When connecting multiple fixtures from one building
facility connection (daisy chaining), maintain a
working distance of 1219mm (4’) between daisy-chain
connections and limit the number of interconnected
fixtures to a maximum of three (3).
DO NOT defeat the safety purpose of a grounding or
polarized plug by removing ground pins or using unsafe
adapters. A polarized plug has two blades—one wider
than the other. A grounding plug has a third ground
prong in addition to the two main conductors. The wide
blade or third grounding prong is provided for your
safety. If the provided plug does not fit your outlet,
consult an electrician to replace your obsolete outlet.
If you replace the power cord, only use one of similar
type and equal or greater current rating.
The URBARN light fixture should only be cleaned as
directed in the manual. You should seek service for
your system by qualified factory support if any of the
following occur:
• The power-supply cord or the plug has been
damaged.
• The unit has been exposed to rain.
• The unit exhibits a marked change in performance.
• The unit has been dropped, or its enclosure or chassis
is damaged.
The product must be installed in accordance with
the National Electrical Code and all applicable local
codes. Proper grounding is required for safety. The
fixture must be installed in accordance with the
applicable installation code by a person familiar with
the construction and operation of the product and any
hazards involved.