URBANGLIDE X-Carve, Manual

Page: 7 / 84

6
2. Start by plugging the switch into the power interface, then plug the other end of
the charger into the product.
3. When the red indicator lights up on the charger, it means that the charging is carried
out correctly, if it is not the case, check all the connections of the cables.
4. When the LED on the charger changes from red to green, the battery is fully
charged. Stop loading. Charge time too long could affect the battery.
5. When the remote-control battery is low, the connection indicator (7) flashes. Turn
off the skateboard and charge the remote control. Do not use the product when the
remote-control battery is low.
U
SE THE
P
RODUCT
1. Make sure skateboard and remote control are fully charged before use. Turn on the
skateboard and the remote control.
2. Stand on the skateboard, both feet apart.
3. Push and hold the button (3) slowly to accelerate. Release slowly to slow down.
Hold the button to stop.
To turn, use the body weight.
4. Slide the "speed mode" button (4) to adjust the speed. It is recommended to use
the "slow" speed when starting.
5. Turn off the skateboard and the remote control when you are no longer using the
product.
If you do not turn off the device, it will remain on for 10 minutes. After 10 minutes
without using the product, it will turn off automatically.
C
LEANING
Never open the product to clean otherwise will void the warranty.
Unplug the product from the wall outlet before cleaning the product.
Clean the outside of the product with a damp cloth. Never use abrasive cloth, scouring
powder or solvent such as alcohol or gasoline.
T
ROUBLESHOOTING
Do not disassemble or modify the battery of the device. Refer all servicing to qualified
personnel. Troubleshooting is necessary if the appliance has been damaged in any way:
plug or power cord damaged, liquid spilled on the product, introduction of small objects
in the product, exposure to rain or moisture, malfunctions, dropping the products …