URBANGLIDE RIDE 69L, Translation Of The Original Instructions

Page: 9 / 54

EN
6
HOW TO USE
Fold the product
1. Unlock the latch by pushing on the security latch
①
.
2. Open the folding latch, pulling it out
②
.
3. Lower the rod gently, towards the back wheel of the scooter
③
.
4. Place the hook (located at the top of the handlebars) in the space intended for it (located
at the level of the rear mudguard)
④
.
Unfold the product
1. Unhook the hook by pressing on the rear mudguard.
2. Raise the rod upright.
3. Close the latch on the road. You'll hear the safety latch snap in if you've folded the latch
Load the product
1. Make sure the charging connector is clean and dry.
2. Start by plugging the switch into the power interface, and then plug the other end of the
charger into the product.
3. When the red indicator lights up on the charger, it means charging is successful, if not,
check all cable connections.
4.
When the LED on the charger changes from red to green, the battery is fully charged.
Stop loading. Charging time that is too long may affect the life of the battery.
Use the product
1. Choose a suitable place to ride.
2. Open the scooter as previously indicated.
3. Press the switch to turn on the scooter.
4. Make sure you remove the stand. Put one foot on the scooter and let the other foot on
the ground.
5. Gently press the throttle and place the foot on the scooter. Press harder on the
accelerator to increase speed.
6.
To brake simply press the brake control on the left side of the handlebars. Press harder
on the brake to slow down faster.
① ②
③
④