QUICK GUIDE MILKSHUTTLE
Urban GmbH & Co. KG • T49 (0) 4484/9380-0 • www.milkshuttle.de
Page 1
For DIMA firmware 3.x starting with serial no. H7
duration of cleaning cycle (minutes)
Cleaning 45.0 C
1: 05:00 33.0 C
selected cleaning
program
(via key 1, 2 or 3)
cleaning water temperature
target value
actual value
Active agitator
start time
(here:
5:00 pm)
I PREPARATION OF FEED:
a) Filling and heating up water / whole milk
Feeding █████
1: 02.0 00.9 █████
feed quantity dispensed: target value / actual value
key pressed
for quantity
selection
charge condition:
battery 2 (propelling drive only)
battery 1
Keep the
C
leaning
key
pressed for 2 seconds, this will call up the cleaning mode:
Press the
S
tart
/S
top
key in order to start the cleaning cycle. If a target
value for the temperature of the cleaning water was set, water will be
heated first.
When the cleaning process is completed, the
C
leaning
key will flash. After the clean-
ing cycle is completed, open the drain valve using the valve lever at the top of the
valve. Let the cleaning water drain completely. Then rinse with clear water.
Keep
H
eating
/a
gitating
key pressed for 2 sec: actvation of clock timer or immediate start-
up of heating process until target temperature is reached (+ post heating if needed):
To dose out portion in bucket press Start/Stop button on the dosing nozzle or the red
push button on the drawbar head or the Start/Stop key on the membrane keyboard.
Press key
1
,
2
or
3
in order to select the desired feed quantity to be dispensed.
Set the agitator switch to level II (fast mode) while preparing feed from calf milk replacer.
Press Start/Stop key. The agitator will then run in continuous mode (5 mins.). Fill the
required amount of milk powder into the heated water and let stir in.
II DISPENSING THE PREPARED FEED
III CLEANING
b) Preparing / mixing calf milk replacer
(not applicable if whole milk is used)
Fill the required amount of water or whole milk into the container of the MilkShuttle.
Keep
F
eeding
key pressed for 2 seconds, this will call up the feeding mode:
Establish circular flow system for cleaning by inserting the dozing nozzle into the holder
on the inside of the container lid.
Roughly wash off the inside of the container and the agitator. Then fill the container
with approx. 30 l of water, add detergent if needed.
SET
+
-
target temper-
ature, duration
of agitating/
break
start time morn-
ing / evening
(3 time pairs)
SET
+
-
feed quantity
SET
+
-
duration
cleaning
cycle, target
temperature
(3 washing
programs)
Key
Heating/
Agitating
Key
F
eeding
K
ey
W
aSHing
1:Heating auto mode
1:17:00 active
clock timer running (optional)
Heating 40.0°C
25.9°C
target temperature
actual temperature
Agitator activity during
heating process
remaining time
Start time heating
Start (of heating) in hh:mm:ss
see reverse side
100.
168_DE SII K
ur
zanleitung MilkShuttle englisch V2.0 R
ev
.0 / 20
17-08-30 RD
1
START
STOP
I
0
II
°C/F
°C/F
↩
↩
Heating Break
00:15
Heating Agitating
00:06
↩
↩
STOP
START
STOP
START
Start
Stop
