Variable
Control
Igniter
TO TURN ON THE HEATER
1.
Push and turn the gas control knob counter-clockwise 90
°
and hold it.
2.
At the same time press the igniter until the flame comes on.
Note: If a
new cylinder has just been connected, please allow one minute for the
air in the gas pipeline to purge out.
3.
Release the gas control knob and check the flame stays on.
4.
If the flame goes out repeat steps 1 to 3.
5.
Release the gas control knob and turn it to maximum temperature in
fully counter-clockwise direction.
6.
A 5 minute complete shut-off period is necessary before re-lighting the
heater.
TO TURN OFF
1.
Turn gas control knob clockwise to the stop position.
2.
Depress gas control knob and turn clockwise to shut off.
3.
Turn the gas cylinder off completely
.
12
Construction and Characteristics
Steel housing, pole and base.
Stainless steel burner with safety tilt shut-off.
Stainless steel flame screen.
Variable pilot control panel with flame failure device.
Heavy duty wheels.
Heat emission from reflector
5
1.
Cylinder Base
2.
Cylinder tank housing
3.
Post
4.
Cylinder housing support
5.
Base of control housing
6.
Air admittance fences
7.
Burner base
8.
Flame emitter screen
9.
Reflector
10.
Gas valve controller
OPERATION & STORAGE
PARTS & SPECIFICATIONS
