ONE MADISON LED MIRROR — INSTALLATION INSTRUCTIONS 1 OF 5
INSTALLATION INSTRUCTIONS
W W W . U R B A N A R C H A E O L O G Y. C O M
REV 07.26.18
Installation Instructions for One Madison LED Mirror
Item code # UA2582 BA
Input: 100-240VAC 1.2 A 50-60Hz
277VAC .5A 50-60Hz
(277VAC for North American only)
Important Safety Instructions
Read all instructions and save for the future.
Do not use attachments not recommended by the manufacturer.
Never use mirror with LED lighting if not operating properly.
Do not use outdoors.
No user-serviceable parts inside. However, if the LED strips inside
need to be replaced the back of the mirror is removable.
Installation Instructions
Prepare the Power Supply
1. The lighting inside the mirror is low-voltage LED lighting. It is powered by an LED driver that is connected to the building’s 110V power
supply. The driver provided is a 24V 100w 4amp driver, Mean Well HLG-100H-24 or equal.
2. The LED driver is remote, not inside the mirror frame, and must be located no more than 15’ from the mirror. If it is located above a
ceiling or behind a wall, the LED driver must be near an access panel making the driver accessible for inspection or repairs.
3. Power/supply connections to the LED driver must be made inside a junction box that can be enclosed.
4. The mirror is supplied with 15 feet of 16/2 CL2P Plenum cable which is to be pulled to the location of the LED driver and connected.
The CL2P wire is rated to run above ceilings.
Prepare the blocking above ceiling
(if mounting to a dropped ceiling)
1. A steel ceiling attachment bracket is provided to be used for the installation of the mirror on a dropped ceiling. The bracket is intended
to make the suspended mirror rigid once installed.
2. The attachment bracket will be screwed into blocking above the ceiling. (screws are provided) The blocking must be located at a height
that places the bottom of the bracket flush with the projected height of the finished ceiling. The blocking must be level and securely
attached to the structure above. The screws that are supplied, will go through predrilled holes at top of the mirror frame, the steel
bracket and then into the wood blocking.
Warning:
Risk of fire and electric shock if
improperly installed. Must be installed
by a licensed electrician according to
the instructions provided.
Caution:
Turn off power at main electrical box
prior to installation.
