Upright X Series, Service & Parts Manual

Page: 20 / 164

Page 2-8
Operation and Specifications
2.3 - Operation
X Series Work Platform
A
FTER
U
SE
E
ACH
D
AY
1. Ensure that the platform is fully lowered.
2. Park the machine on a firm, level surface, preferably under cover, secure against vandals,
children, and unauthorized operation.
3. Turn the Key Switch to OFF and remove the key to prevent unauthorized operation.
P
ARKING
B
RAKE
R
ELEASE
Perform the following only when the machine will not operate under its own power and it is neces-
sary to move the machine or when winching onto a trailer to transport.
NOTE: X31N models have two identical brake adjustment nuts located on both sides of the ladder. The
X20N, X20W, and X26N have only one.
Figure 2-6: Parking Brake Release
The Brake Adjustment/Release
Nut(s) is/are located at the rear of
the machine to the right and/or left
of the ladder.
1. To release the brakes, turn the
nut(s) counterclockwise until
the brakes disengage the
tires.
2. The machine will now roll
when pushed or pulled.
3. To re-engage the brakes, turn
the nut(s) clockwise until the
brakes have fully engaged the
tires.Verify that the brakes
have fully engaged the rear
tires before operating the
machine by testing their abil-
ity to hold the machine on a
22% grade.
REAR
REAR
Parking Brake Release
Parking Brake Release
W A R N I N G
! !
Never tow faster than 1 ft./sec. (0,3m/sec.)
Never operate the work platform with the parking brakes released. Serious
injury or damage could result.
060571-005