7
UPLIFT Desk 1-800-349-3839
M.
Turn the assembled desk right-side-up. With two people, grab the desk by the base (not the
desktop) and turn the desk right-side up. Adjust the Leveling Studs on the Feet (Part #2) as needed.
L.
IN THIS FOLLOWING STEP, DO NOT OVERTIGHTEN SCREWS. OVER TIGHTENING MAY
CAUSE THE PLASTIC ON THE COMPONENTS TO BREAK.
Place the Keypad (Part #8) so the front of the keypad runs
flush with the desktop edge (or recessed up to 1/8”).
The Keypad can be placed anywhere along the front edge
of the desk, but we recommend placing it near the side so
it doesn’t interfere with your chair or legs when seated.
Use qty 2 of the Pan Head Screws (Part #13) to attach
the Keypad (Part #8) to the desktop. Use the adhesive-backed
Cable Clips (Part #14) to secure all wires so they don’t sag.
K.
IN THIS FOLLOWING STEP, DO NOT OVERTIGHTEN SCREWS. OVER TIGHTENING MAY
CAUSE THE PLASTIC ON THE COMPONENTS TO BREAK.
Use qty 2 of the Pan Head Screws (Part #13)
to attach the Control Box (Part #7). Ensure enough
clearance at the wire ports for cable connections.
N.
Plug the Power Cord into a 110v outlet.
IMPORTANT!
You must RESET the desk prior to use!
Press and hold the DOWN button on the Keypad until the desk reaches
its lowest height. Release the DOWN button. Press and hold the DOWN
button again until the LED display reads “RST” or about 10 seconds on
non-LED handset models. Release the DOWN button. Press and hold
the DOWN button again until the desk lowers a little bit more, slightly
rises and stops. Release the DOWN button. Your desk is now ready to use.
To program up to four presets:
Use the up/down buttons to find a desired height, then press “M” followed by a number 1 – 4.
7
8
8
MAKE SURE NO OBSTACLES ARE IN THE DESK’S PATH.
MAKE SURE ALL CORDS ARE OF A LENGTH THAT WILL
ACCOMMODATE THE CHANGE IN HEIGHT.
!
We recommend you pre-drill any holes needed for
fasteners connecting the Control Box to the top. This will
make it easier to attach the screws and will greatly lessen
the stress caused by driving a screw into the desktop material.
Never use countersunk screws to fasten into the desk-
top. This will cause much greater stress on the desktop.
Ensure any screw used will not puncture through the
desktop surface or otherwise damage the material.
!
!
