© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
(fig. 01)
(fig. 02)
Allen wrench
(L-shape)
Base
Casters
(qty 5)
Back
(with armrests)
M6x20 screw
(qty 2)
Plastic cap
(qty 2)
Outer cover
(optional)
Inner cover
(optional)
Note: may be pre-installed on Chair’s Back
Cylinder
Seat
Headrest
M8x20 screw
(qty 3)
Flat washer
(qty 3)
Step 1
Insert the Casters into the holes on the Base, and press them firmly
to secure them in place.
Flip the Base, Casters down, onto the floor and insert the Cylinder
into the Base in the orientation shown, with the smaller diameter
end up. Be cautious around the end of the Cylinder to prevent it
from getting oil on you or your clothes.
Step 2
Place the Seat upside down on the edge of a stable surface, such
as a table.
Line up the holes for the Back and the Seat. Have a friend help
keep it steady while you attach the Back to the Seat. Using the
Allen wrench, screw the Back and Seat into place using three
M8x20 screws and three Flat washers.
Note:
These screws and washers may arrive partially inserted
into the Back, upon unboxing. Simply remove, and then attach
the Seat and Back together.
Step 3
Lower the chair assembly onto the Cylinder to secure it in place.
NOTE
If you don’t want to install the Headrest, take the Outer cover (a)
and Inner cover (b) and attach them as shown. These cover up
the places that the Headrest attaches.
If you want to install the Headrest, proceed to Step 4.
(a)
(b)
Step 4
The Headrest fits into the Back in a specific way. Look for the
lower holes on the rubber portion of the headrest (fig. 01) and the
recessed tab in the Back (fig. 02). These two parts fit together.
Angle the Headrest, as shown. Lining up the slot on the Headrest
with the tabs on the Back, tilt it forward firmly, fitting the two
parts together.
Next, insert two M6x20 screws and tighten using the Allen wrench.
And finally, place the two Plastic caps over the screws.
Package Contents
Vert Ergonomic Chair
SKU: CHR458
