© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
11
Future desk accessories:
UPLIFT Desk offers various desk accessories that will
mount easily to our innovative, patent-pending desk
frame. Accessories will either mount directly to the
Crossbar ends, or will require the two included Anchor
plates (C11).
Read your accessory’s instructions to see if you’ll need
the Anchor plates for installation. If so, attach them to
the frame using four M8x10 machine screws (H7), and
tighten using the 5mm Allen wrench (H8) at the loca-
tions mentioned in the accessory’s instructions.
C11
H7
patent pending
Step 14
Double check that all screws on the desk are tight.
And then check all screws again and make sure they’re
tight. This isn’t a typo, it’s important and it’s far easier to
tighten them with the desk upside down than it is later.
Be careful not to miss the screws marked with an ar-
row in the diagram. Don’t forget that one of the screws
is under the Control box.
Step 13
Place a foot onto one of the Leg assemblies as shown.
Loosely start four M6x14 Machine screws (H2) us-
ing the 4mm Allen wrench (H6). Do not tighten the
screws until all four have been started
Note:
If you’re assembling a C-Frame, make
sure the long end of the C-frame feet (C1) are
facing towards the front of the desk, in the
same direction as the Side brackets.
Once all four screws have been started, tighten all the
way using the 4mm Allen wrench (H6) and the Allen
wrench handle (H15). Repeat this step for the other
foot and Leg assembly.
Note:
If you purchased Casters, remove the leveling
pads and install the Casters now.
H2
C1
ACCESSORY INSTALLATION (continued)
C
T
C
T
C
T
Attention! Use the Allen
wrench handle (H15) when
tightening these screws.
