UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 5
Insert Vesa mount (with monitor attached) into the Horizontal arm.
Once each arm is assembled, you will need to tighten the set screws located
at each joint to prevent the arm from lifting apart or drifting. Use the 3mm
Allen wrench provided. Make sure not to overtighten the set screws.
Step 8
Screen Distance:
Set to approximately 18”-28” from user. To reduce eye strain,
place monitor about an arm’s length from your eyes. If print is too hard to read, it
is better to make the print larger on your screen than to move the screen closer.
Monitor Height:
The top of the monitor should be level with your eyes.
Monitor Tilt:
The monitor should be tilted slightly up so it’s easier to see the
screen when the top of the monitor is level with your eyes. You can use the
13mm flat wrench included in this package, to adjust your Monitor’s tilt.
Step 7
The Gas arm is factory set for a standard 17” monitor. If you find that after you
place the monitor into the proper position that it either lifts or drops, then the
tension of the Gas arm needs to be adjusted. To do this, adjust the set screw
located at the lower section of the Gas arm.
You will need to turn the set screw with the supplied 4mm Allen wrench in the
appropriate direction to increase or decrease the supporting weight. Adjust
the tension of the Gas arm until the monitor holds its position when you let it go.
®
Single Monitor Arm
UPL020
Step 6
Insert the provided Wire clips into the underside of the Horizontal and Gas arm.
Run the cables through the clips. Make sure the cables are not pulled tight.
There should be some slack in the cables to allow the arm to move freely
without being restricted.
Copyright Notice:
This guide is a component of the UPLIFT Desk Single monitor arm. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: uplift
-
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
!
Read all instructions before assembly. Failure to assemble properly may result in
product damage or injury.
