© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 2
Connect the tray mount (part 12) to the Adapt Mobile™ arm using four M6x-
12mm screws (part B) and tighten with the small Allen wrench (part 18).
Affix the mount cover (part 13) as shown.
Step 3
Connect the tray (part 14) to the tray mount (part 12) using four M6x12mm
screws (part B) and tighten with the small Allen wrench.
Bolt-Thru Step 1
Insert the long screw (part 8) into the bolt-thru top clamp (part 7)
Bolt-Thru Step 2
Connect the assembly to the Adapt Mobile™ arm using the three
M6x12mm screws (part A) and the small Allen wrench.
Bolt-Thru Step 3
Place the arm gasket (part 3) under the arm’s mount, and apply the place
the bolt gasket (part 9) onto the bolt bottom clamp (part 10) as shown.
Slide the arm assembly into the hole on your desk.
Bolt-Thru Step 4
Slide the the bolt bottom clamp (part 10) over the screw, then screw on
the bolt-thru knob (part 11) and tighten, to keep the Adapt Mobile™ arm
securely fastened to the desk.
Make sure that the clamp is secure. If the
clamp is too loose, the unit may wobble or fall.
Bolt-Thru Assembly -
for holes 8.5mm to 70mm
