© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
®
UPLIFT Adapt Mobile
™
Instructions
UDA120~mobile
There are two ways to attach your UPLIFT Adapt Mobile™ to your desktop: Clamp assembly, and bolt-thru assembly.
Clamp Assembly -
Attach the arm to the back of your desk....
Clamp Step 1
Connect the top clamp (part 3) to the Adapt Mobile™ arm using the three
M6x12mm screws (part A) and the small Allen wrench.
Clamp Step 2
Place the Arm Gasket (part 2) under the arm mount, and the clamp gas-
kets (part 5) to the bottom clamp (part 6).
Clamp Step 3
Connect the bottom clamp assembly (part 6) to the top clamp assembly
by using M6x14mm (part C) and the small Allen wrench.
Clamp Step 4
Turn the knobs counterclockwise to loosen them.
Slide the assembly onto your desk and turn the knobs clockwise to
tighten the clamp to the desk.
Make sure that the clamp is secure. If the
clamp is too loose, the unit may wobble or fall.
Snap the Cable cover (part 4) to the back.
Part 1
Adapt Mobile™ arm
Screws
Tools
Part 3
Top Clamp
Part 7
Bolt top clamp
Part 12
Tray mount
Part 4
Cable Cover
Part 8
Bolt
Part 13
Mount cover
Part 5
Clamp Gaskets
(qty 2)
Part 9
Bolt gasket
Part 14 - Tray
Part 6
Bottom Clamp
Part 10
Bolt bottom clamp
Part 2
Arm gasket
Part 11
Bolt knob
Part A
M6x12mm screws
(qty 3)
Part B
M6x12mm screws
(qty 8)
Part C
M6x14mm screws
(qty 2)
Allen wrench
(small)
Allen wrench
(large)