© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 5
Finally, lower the tray, slide it back on the track and install the front
bumper using three (3) Wood screws.
Step 6
Attach the foam palm support onto the front of the Bamboo tray. Place the
mousepad and cord catcher to the desired side.
The non-slip Adhesive pads can be placed over the heads of the machine
screws, or in any other position on the board.
Use the Wire clip anywhere to secure loose wires to prevent snags.
Rotate
The Keyboard Tray rotates at the point where the mechanism attaches to the
Track. It can rotate 360 degrees.
360°
Copyright Notice:
This guide is a component of the UPLIFT Desk Large Bamboo Keyboard Tray. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website:
upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
!
CAUTION:
Read all instructions before assembly. Failure to assemble properly may
result in product damage or injury.
Tilt
To adjust the tilt of the tray, turn the knob at the center of the tray.
Height
To adjust the height of the tray up and down, push down on the back of the
tray while lifting the front.
Adjustment Guide
Step 4
Lift up on the front of the tray and lower the back to relieve pressure on
the shipping pin and remove it.
