© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
4
ASSEMBLY INSTRUCTIONS
Step 1
Slide a Crossbar end (C2) into the tube extensions on
a Leg assembly (C1) in the orientation shown for each
piece. Be sure to slide the Crossbar end in as far as it
will go. Then lock the Crossbar end in place using four
of the M8x8 Set screws (H1) using an Allen wrench.
Repeat this step with the other Crossbar end and Leg
assembly.
Step 3
Slide the Crossbar rails (C3) into the Crossbar end of
one of the assemblies from Step 1. Then, slide the sec-
ond assembly from Step 1 onto the opposite ends of
the Crossbar rails. Slide all parts together as far as they
will go. Doing so will make the full assembly easier to
lift onto the desktop in the next step.
Step 4
Before proceeding, inspect top surface of desktop
for damage. We recommend placing a blanket on the
floor to prevent the desktop from scratching. Place
the UPLIFT desktop on the floor, with the mounting
holes facing up. (If you are using your own desktop,
there will not be mounting holes).
Next, place the completed frame assembly on top
of the desktop, aligning the slots in the Leg assem-
blies with the metal inserts or pre-drilled holes in the
desktop (Step 5 will help you determine which holes
to use depending on your desktop’s size). If needed,
adjust the width of the frame in order to properly
align all of the holes.
Lift the frame slightly while aligning the holes to prevent
the rubber grommets from coming out of the Crossbar
ends or Leg assemblies. If a grommet does come out, it
can be easily replaced in its slot on the frame.
Step 2
Orient the Crossbar rails (C3) so that the Center indi-
cator marks are facing up.
Center indicator marks
C2
C1
H1
C3
