© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
RESET
6-8’’
Step 4
A. Line up the Keypad with the two mounting holes
on the Mounting Plate and attach it with the two
#M4x10mm Machine Screws.
B. Do not over tighten to avoid stripping.
Step 5
A. Remove the adhesive backing from a Cable Mount
and stick it 6” to 8” directly behind the Paddle.
Press and hold the adhesive to the Desktop for
about 30 seconds.
B. Wrap the Cable Mount strap around the cable and
pull it closed but not tight around the cable, leav-
ing slack between the Cable mount and the cable.
C. Plug the end of the Keypad’s cable into the port
marked “HS” on your UPLIFT Desk control box.
D. You can use the remaining Cable Mounts to orga-
nize your Keypad cable and prevent it from snag-
ging on anything when adjusting the desk’s height.
The Cable Mounts work best when stuck directly
to one of the frame’s metal components.
Step 6
If you are installing the Advanced Paddle Keypad on
a newly assembled desk, you must first perform the
following Reset Procedure:
• Press and hold the Paddle down until the desk
stops at its lowest position, then release.
•
Press down and hold again until the display
reads RESET, then release.
• Press down and hold one more time until the
desk lowers slightly, rises and stops, then release
the button.
• Once the numeric height is displayed, the reset
is complete and the desk is ready for use.
