© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
Copyright Notice:
These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift
-
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
90.014.01.0469 v.A
CAUTION:
Read all instructions before assembly. Failure to assemble or operate properly may
result in damage or personal injury. Retain manual for future reference.
CAUTIONS & WARNINGS
!
!
AI-FRM055-1.0
Troubleshooting
If your desk does not respond when you try to raise it or low-
er it, or if the Keypad displays error messages (“EO1” through
“E12”), check to make sure all the cables are secure (legs to
cables, cables to control box).
If the problem persists, perform a Hard Reset:
1. Unplug the power cord and press down on the paddle
for 30 seconds.
2. Plug the power cord back in.
3. Perform the Reset procedure (see Page 1, Step 3)
Note: If the desk is unplugged or if you lose power, you may
need to perform the Reset Procedure
E07
!
Vibration Mode
With the Vibration Mode activated, the Advanced Paddle Key-
pad will vibrate when the Standing Reminder time period has
expired. If the Vibration Mode is off, you will only be notified
visually on the display when the timer runs out.
Enter the Functions Menu and tap the paddle until you find the
Vibrate icon. Press the side button to enter. Cycle through the
following options, and click the side button to accept the option
you want.
Press side button to:
Activate Vibration mode with three short pulses
Activate Vibration mode with two long pulses
Activate Vibration mode with two short pulses
Deactivate Vibration mode
Go back to the main menu
4 / 5
5 / 5
4 / 5
3 / 5
2 / 5
1 / 5
OFF
OFF
OFF
OFF
OFF
The Functions Menu (continued)
CODE
DESCRIPTION
TROUBLESHOOTING SOLUTION
H01
Overheated
The desk motor has a 10% duty cycle to protect it from overheating. For
example, in a 20 minute period, if your desk motor is activated for 2 minutes,
you will want to let it rest for 18 minutes. Otherwise you may see an H01
code on your keypad.
E01-E06
Firmware or
connectivity issues
Check all cables to ensure they’re all firmly plugged in, and perform Reset
procedure above
E07-E012
Legs are uneven
Perform Reset procedure above
If the error message persists after performing the Reset procedure, or if there is a height difference between the
legs which exceeds 1.5’’, contact UPLIFT Desk at the email address or phone numbers listed at the bottom of each
page of these instructions.
