Uplift Desk Advanced Paddle Keypad FRM055 Assembly Instructions Download Page 1

© UPLIFT Desk

 • 800-349-3839 • [email protected] • upliftdesk.com

RESET

Package Contents

Advanced Paddle 

Keypad

Machine screws

(qty 2)

Mounting plate

Advanced
Paddle
Keypad

Wood screws

Machine screws

Cable mount

(qty 3)

Wood screws

(qty 2)

Mounting plate

Advanced Paddle Keypad

FRM055

If you own a drill, you can make this a little easier 
by drilling pilot holes at each pencil mark using a 
1/8” (or 3mm) diameter bit. 

Note:

 DRILL NO DEEPER THAN 1/2”. To ensure 

this, we recommend wrapping a piece of tape 
around your drill bit 1/2” from the tip. Stop drilling 
just before the tape touches the desktop. 
Then attach the Mounting plate to the desktop with the two 
Wood screws.
Finish by connecting the Advanced Paddle Keypad to the 
Mounting plate using the two Machine screws.

Step 1 - Attach the Keypad to Desktop

If your desktop has pre-drilled holes on the underside, line up 
the Mounting plate with the holes in the orientation shown to 
the left. Attach it to the Desktop with the two Wood screws.
If your desktop does not have pre-drilled holes, the Keypad 
can be placed anywhere along the front edge of the Desk-
top. Ideal placement leads to less interference with your legs, 
chair, or accessories. Once the mounting location is chosen, 
hold the Mounting plate 3/8” back from the front edge of the 
Desktop, and make a pencil mark at each of the two front 
hole locations.

Step 2 - Install the Cable

Remove the adhesive backing from the Cable mount and stick 
it 6” to 8” directly behind the paddle. Press and hold the adhe-
sive to the Desktop for about 30 seconds. Then wrap the Cable 
mount strap around the cable and pull it closed 

but not tight

 

around the cable, leaving slack in the cable between the Cable 
mount and the cable. 
Plug the end of the paddle’s cable into your UPLIFT Desk con-
trol box, into the port marked “HS.” Use the remaining Cable 
mounts as you wish to organize your cable. 

6-8’’

1/2’’

Step 3 - Reset Procedure

If you are installing the Advanced Paddle Keypad on a newly 

assembled desk, you must first perform the Reset procedure:

• Press and hold the paddle down until the desk stops at its 
lowest position, then release. 
• Press down and hold again until the display reads RESET 
then release. 
• Press and hold down one more time until the desk lowers 
then rises slightly, then release. Once numeric height is dis-
played, the reset is complete and desk is ready for use.

Reviews: