© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
®
Horizon™ Dual Monitor Arm Instructions
ACC305
Clamp Step 2
Screw the Clamp bolt (part 13) up from the bottom of the Clamp bracket,
and insert the Clamp plate (part 12) into the tab at the tip of the Clamp bolt.
Clamp Step 1
Slide the Outer wire clip (part 14) into the back notch of the Arm’s
base. Attach the Clamp bracket (part 11) to the Arm’s base with three
M6*12 screws (part 4). Secure the screws with the medium Allen wrench
(part 6).
Clamp Step 3
Apply the Clamp gasket (part 15) under the Arm’s base.
Match the holes in the gasket to where the placement of the screws are.
Clamp Step 4
Slide the assembly onto your desk, and turn the Clamp bolt to tighten
and affix to desk.
Part 1
UPLIFT Horizon™ Dual Arm
Part 4
M6*12 screw
(qty 3)
Part 3
Washer
(qty 4)
Part 7
Allen wrench
(large)
Part 11
Clamp bracket
Part 8
Boxed wrench
Part 12
Clamp plate
Part 9
Cable cover 1
Part 13
Clamp bolt
Part 10
Cable cover 2
Part 14
Outer wire clip
Part 15
Clamp gasket
Part 16
Bolt plate
Part 17
Bolt assembly
Part 18
Open-end wrench
Part 19
Nut
Part 20
Inner wire clip
Part 21
Bolt gasket
Part 2
M4*12 screw
(qty 8)
Part 5
Allen wrench
(small)
Part 6
Allen wrench
(medium)
Clamp Assembly -
Attach the arm to the back of the desk. Clamp will fit desks up to 1.7’’
Step 1
Attach Monitor Arm to desktop.
There are two ways to attach your UPLIFT Horizon™ Dual Monitor Arm to your desktop: Clamp and Bolt-through assembly.
ACC305/R01
