© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 2
Use two washers (part E) and two screws* and screw them in by hand.
*Most monitors will use the M4x12 (part A) screws, but if those seem
loose to you, use the M5x12 (part B).
Step 3
Place the monitors onto the on the open holes on the Vesa plate.
See Fig. 1 for specific placement.
Step 4
Using 2 more washers and screws, screw into the lower two holes on
the Vesa mounting plate. (see Fig 2).
Repeat steps 2-4 with your second monitor.
When finsihed, tighten up all screws from this step and step 2.
Fig. 1
Fig. 2
Bolt-Thru Assembly -
for holes 8.5mm to 70mm
Bolt-Thru Step 1
Insert the long screw (part 8) into the bolt top clamp. (part 7).
Bolt-Thru Step 2
Connect the assembly to the Adapt View™ arm using the three M6x12mm
screws (part C) and the small Allen wrench (part F).
Bolt-Thru Step 3
Place the arm gasket (part 2) under the arm’s mount, then slide the assem-
bly into the bolt on your desk. Place the bolt gasket (part 9) onto the bolt
bottom clamp (part 10) as shown.
Bolt-Thru Step 4
Slide the bolt bottom clamp (part 10) over the bolt as shown. Screw on the
bolt-thru knob (part 11) and tighten, to keep the Adapt View™ arm securely
fastened to the desk.
Make sure that the clamp is secure. If the clamp is too
loose, the unit may wobble or fall.
