13
14
The following tools are required and should be available:
To mount the amplifier in the dashboard of the automobile (depending on package):
•
Screw driver for Torx – size TX 20
or screw driver or small ratchet wrench with a bit head and bit size TX 20
Screw driver for slot screw – size about 2 mm
To mount the door loudspeaker
Screw driver for Torx – size TX 20 (see above)
or screw driver or small ratchet wrench with a bit head and bit size TX 20
Screw driver for Torx – size TX 30
or screw driver or small ratchet wrench with a bit head and bit size TX 30
Screw driver for cross screws – size PH 2
or screw driver or small ratchet wrench with a bit head and bit size PH 2
Screw driver for cross screws – size PH 3
or screw driver or small ratchet wrench with a bit head and bit size PH 3
Screw driver slot screws – size about 5 mm
Accumulator screw machine or drill machine
5 mm bit
Side cutter
Electrical pliers
Tools
If you bought a set without amplifier, you can omit
the following section.
Step 1
Loosen the radiocover which is only clipsed as
shown. Disengage the cable with plug.
Step 2
Loosen the cover of the air condition which is only
clipsed as shown (illustration 2).
Step 3
Now you have the radio and the ventilation unit in
front of you which are each fastened by 4 screws.
Loosen all screws.
Illu. 1
Illu. 2
Illu. 3
Illu. 4
Step 4
Now remove the ventilation control. Pull out the cables on the ventilation control and
remove them. For this purpose first loosen the red clips on the plugs by pulling.
Attention:
The clips can only be loosened, but not
completely removed.
Step 5
Carefully pull the radio out until the back side of the radio is
accessible. Pull out the quadlock plug and the antenna plug
from the radio and remove them (illustration 4).
Please pay attention to the latch of the quadlock plug. First
the clamp in the center must be released and then turned
upward.
The antenna plug (white and light brown) must be released
from below with a slot screw driver.
Mounting of the Amplifier (Dashboard))
