7
NOTE!
If the restore all factory default settings feature is not enabled, the restore factory settings will retain the
network and user settings.
3
Web Operations
3.1
Login
The default static IP address of the device is 192.168.1.13. The device also supports simple login using the IP
address of 192.168.0.13 and subnet mask of 255.255.255.0.
The Dynamic Host Configuration Protocol (DHCP) is enabled on the device by default. If a DHCP server is used in
the network, the IP address may be assigned dynamically. In this case, use the actual IP address for login. For
operations to be performed when a dynamic IP address is assigned, click
The steps of logging in to the Web interface (Internet Explorer 10 as an example) are as follows:
(1)
Enter the IP address in the address bar of the browser and press
Enter
.
(2)
A plug-in installation prompt as shown in the figure below is displayed when you log in to the Web interface
for the first time. Follow instructions on the interface to complete the plug-in installation (all browsers need
to be closed for the installation), restart the Internet Explorer, and log in to the system again.
NOTE!
To manually load the ActiveX, enter
http
://
IP address
/ActiveX/Setup.exe in the address bar and press
Enter
.
(3)
Enter the username and password, and then click
Login
.
