UNV NVR202 Series, Quick Manual, Page: 11 / 29

4
8. Connect data cables and power cables to the motherboard.
9. (Optional) To install another hard disk (if applicable), repeat the
above steps.
10. Replace the cover and tighten the screws. Do not place the cables
on the hard disk(s).
When you remove the chassis cover facing the rear panel, the hard
disk slots are numbered as follows.
Installing the Device
Leave a minimum space of 30 cm at the front and back sides of the
device and a minimum space of 10 cm at the left and right sides of the
device for heat dissipation.
Follow the steps:
1. Remove the stickers of the supplied foot pads and attach the foot
pads to the bottom of the device, as shown in the figure below.