aS01-aS02- Floor or CeiliNG SaFety tHerMoStat alarM
STATIC OvEN
Starting from s/n 2017D0025535,
a protection shield for covering the
bottom safety thermostat has been
introduced to reduce the negative
effect of the current position, avoiding
the AS01 alarm when the temperature
is set to the maximum value.
YES
NO
Test 1
NO
Test 2
Replace the safety
thermostat
NO
YES
Replace cable
harness
NO
YES
Replace the
power board
YES
End
NO
YES
AS01-AS02 floor
or ceiling safety
thermostat alarm
Wait for the
cooling down of
the deck oven
Reset the thermostat
and analyse the
possible causes such
as oven installation,
external heating
sources,
etc.
Measure the
electrical continuity
of the cable from
the P6 socket to the
safety thermostat
plug. Meaure the
continuity PIN to
PIN.
Turn off the
power supply.
Disconnect P6
socket and test
the electrical
continuity
between the
pins with the
multimeter set
to ohm
Do you
have electrical
continuity?
Has the
safety thermostat
triggered? It
triggers at 320 C
(608 F)
Measure the
electrical continuity
of the safety
thermostat as
shown in the
picture with
the multimeter
set to ohm
Do you
have electrical
continuity in the
wirin g?
Do you
have electrical
continuity?
Restore the cable
harness and test
the oven
Does the
alarm persist?
194
Summary of Contents for MINDMaps BAKERTOP
