12
Regulatory statements
Intermec hereby declares that the MaxiScan 2100 has been tested and found compliant with the below
listed standards as required by the EMC Directive 89/336/EEC as amended by 92/31/EEC and by the Low
Voltage Directive 73/23/EEC as amended by 93/68/EEC:
EN50081-1 (1992)
EN50082-1 (1998)
EN60950 (1993)
USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment is intended for operation in a commercial environment, in compliance with the requirements for a
Class A digital device, pursuant to part 15 of the FCC Rules. It has also been tested and found to comply with the
more stringent requirements for a Class B device, pursuant to part 15 of the FCC Rules. It generates, uses and can
radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause interference
to radio communications. If this equipment causes interference, the user will be required to correct the interference at
the user’s own expense.
Canada: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
Australia-New Zealand: This equipment has been tested and found to conform to the Australian EMC
framework concerning Class B digital devices, prescribed by the Australian and New-Zealander
standard AS/NZS 3548.
The information contained in this document is for informational purposes only and is subject to change without notice.
No part of this document may be copied or reproduced in any manner without the prior written permission of Intermec
Technologies Corporation.
MaxiScan products are covered by patents issued or pending in the USA and other countries.
The word Intermec, the Intermec logo, MaxiScan and EasySet are either trademarks or registered trademarks of
Intermec.
Throughout this document, trademarked names may be used. Rather than put a trademark (™ or ®) symbol in every
occurrence of a trademarked name, we state that we are using the names only in an editorial fashion, and to the
benefit of the trademark owner, with no intention of infringement.
North America / Asia Pacific / Latin America • 6001 36th Avenue West, PO Box 4280, Everett, WA 98203-9280
Tel: +1 425 348 2600 • Fax: +1 425 348 2833 • U.S. service and technical support, tel: 1.800.755.5505 • Canadian
service and technical support, tel: 1.800.688.7043
Europe / Middle East / Africa • Sovereign House, Vastern Road, Reading RG1 8BT, England
Tel: +44 118 987 9420 • Fax: +44 118 987 9416
Internet: http://www.intermec.com
E-mail: [email protected]
Support: http://datacapture.intermec.com
© 05/99 Intermec Technologies Corporation All Rights Reserved
N309
