23
(M4 x 12) and the two fixing plates provided for this purpose. Caution: The
power cord underneath the base must be protected with the provided rubber
mantle! Unscrew the fixing plates on the underside of the base, remove the
rubber mantel. Place the rubber mantel around the power cord and then fix
both in place with the fixing plates.
11. Ensure that all parts are correctly interconnected to ensure safe operation.
THE IDEAL LOCATION
1. The appliance is only suitable for
outdoor areas or for operation in
very large, well ventilated rooms.
2. Do not use the appliance outdoors
in storm, rain, snowfall, etc.
3. Ensure that an adequate distance
(at least 100 cm is maintained to
branches, bushes, shrubbery, fur-
niture, curtains, or other flamma-
ble objects.
4. The distance to the ceiling must
be at least 30 cm.
5. Only place the appliance in opera-
tion in a vertical position.
6. Only place the appliance on a
solid and level substrate. Do not
place the appliance on soft sur-
faces (sofa, bed) because the
appliance can tip over.
7. In addition, ensure that the appli-
ance is not set up on deep-pile
carpets or in dusty environments.
8. For safety reasons, the appliance
must not be used in the vicinity
of sinks, bathtubs, ponds, swim-
ming pools or water connections.
9. Never place the appliance directly
under an electrical outlet, and
ensure that the power socket used
is easily accessible at all times.
10. Check whether the power cord is
routed in such a manner that no
one can stumble over it.
11. The power cord should not touch
any housing parts, this could
cause the cable to melt.
Be aware that the appliance
can become very hot - danger
of burns! Particularly ensure
that children are kept away
from the appliance.
OPERATION
1. Comply with all safety instruc-
tions and safety regulations.
2. Ensure that you have selected a
suitable location.
3. Plug the mains plug of the
appliance into an electrical
outlet
(220–240 V~,
50 Hz,
13 ampere).
4. To adjust the tilt angle of the
reflector, press the silver-coloured
button (7). Then bend the reflec-
tor in the desired direction (atten-
tion: the reflector can only tilt in
one direction!), and then release
the button.
