7
1
Red pilot light
2
TX button
3
Sliding switch 1 2 3: Set sensor number (transmission channel)
4
Battery compartment
5
Loop for hanging
Note:
If you are going to use the wireless sensor included in the package, there is no need to
change the transmission channel inside the outdoor sensor.
Changing the transmission channel is only necessary when you are going to add additional
wireless outdoor sensor. See “ How to add extra sensors “ on Page 10.
How to set up
Insert batteries
1. Insert 2x AA batteries into the wireless sensor. Pay attention to the correct polarity. While
the sensor is transmitting, the red LED indicator will flash.
2. Open the battery compartment of the weather station and insert 3xAAA batteries in the
correct polarity. Close the battery compartment.
(Note: The screen will turn off after 10s and you will need to touch the
button to
activate it.)
Setting the weather symbol
When the weather station is insert batteries on the first time, it will enter the weather
symbol setting. You can follow below steps.
1.You will see the weather symbol starts flashing, and the default is half sunny. It will
automatically adjust to the correct symbol. However, if you want to shorten the reception
time of the weather station, you can manually adjust it through
INDEX
button.
2.Press the
MEM
or
CH
button to save the setting.
