P a g e
| 3
Steel Body, Automatic Wood Pellet Feed Hot Water Boiler Operation and Maintenance
Manual
INTRODUCTION
Thank you for choosing Ecopel wood pellet fueled boiler.
Please read the user manual carefully before installing and operating your
product and retain the user manual for the duration of the product. Do not touch
or mix any part of the product other than those permitted in this manual.
The installation, maintenance and service of the boiler requires expert technical
team.
These operating instructions and regulations must be observed for the installation of the boiler, the
selection of the appropriate location for the installation, the installation of the boiler water installation
and the design of the chimney.
ÜNMAK Pellet boilers are high efficiency, steel welded hot water boilers designed for burning wood
pellets only. 6 - 8 - 10 mm diameter wood pellets are suitable for burning. These boilers are only used
for heating the heating system, they are not suitable for direct domestic water heating. However, it
can produce domestic hot water with the help of a boiler or heat exchanger. The energy required for
the domestic water will be taken from the boiler energy.
ÜNMAK Pellet boilers convert the chemical energy of the fuel in the fuel loading chamber into heat
energy by combustion and load it on the water which is the heating fluid.
Powdered fuels will fly through the combustion chamber with the system fan so there will be no
efficient combustion. As the powder fuel will collect more moisture, it will even lead to auger blockage
within the feed screw. Depending on the calorific values of the fuels, the heat from the boiler to the
water may go outside of the declared values.
ATTENTION
Your user manual must be read carefully and stored with the enclosed warranty for the
lifetime of the boiler.
