INSUBH0515
4
to Reduce the Risk of fiRe, do not
stoRe oR use gasoline oR otheR
flammable vapoRs and liquids in the
vicinity of the heateR.
do not mount in contact With
combustible mateRial. do not mount in close
pRoximity to anotheR unit.
- The unit must be secured to a wall, 12 in (305 mm) away from the floor
and adjacent walls (Fig.1). A minimum distance of 24 in. (610 mm) from
the floor to the bottom of the unit must be respected when the towel
holder is installed.
- The UnIT CAnnoT be CoveReD oR hIDDen by A DooR.
- Drill three holes with a diameter slightly smaller than the one for the
plastic pins provided.
- Insert the pins.
- Insert the two top screws provided, leaving a gap of 5/16 in (8 mm)
between the screw head and the wall (Fig.2).
- Hang the unit on the two installed screws while holding it securely in
your
hands;
caution! Before letting go of the unit, check that
it is securely hung on the two screws.
- Secure the unit with the third screw at the bottom (Fig.2).
- Figure 3 on the right indicates the airflow generated by the heater.
This air corridor must remain clear in order to allow good air
circulation and to ensure that the unit operates efficiently.
- Leave at least 12 in (305 mm) in front of the unit.
- Do not install the heater below an electrical outlet.
installation
figure 1
12" (305mm)
Minimum
2
2
2
Minimum
12" (305mm)
Minimum
12" (305mm)
WALL
WALL
FLOOR
figure 3
12" (305mm)
12" (305mm)
AIR
INLET
AIR
OUTLET
installation
n.b. cut off power supply at circuit breaker/fuse before
proceeding to the installation and wiring connections.
this product must be connected by a certified electrician,
according to the electrical and building codes effective in
your region. consult the wiring plan found on the unit.
- Make the electrical connections inside the junction box located at
the back of the unit (Fig.4).
- Installation of this product must be made in accordance with all
national and local building codes.
- The electrical connections must be made with a 12-gauge
2-conductor wire.
- This unit is double insulated. Because of the insulation feature, it
does not need to be grounded.
electrical connection
figure 4
jUnCTIon
BOX
figure 2
7 1/16"
(180mm)
14 5/16"
(363mm)
