5
Connecting the Loop pad or Sofa loop
Place the loop pad on your seat, either on top of or under the cushion. The Sofa loop is
placed around the sofa on the floor, for example under a carpet. Make sure that you place
the lead cable in such a way that nobody gets tangled in it. Connect the loop pad’s /sofa
loop’s DIN connector to the DIN socket of the amplifiers rear side.
Mains power connection
First connect the power adaptor to the socket marked on the amplifier. Then connect the
adaptor to the power outlet.
Settings
Univox® AutoLoop is fully automatic. No settings are needed.
Maintenance
Under normal circumstances Univox® loop amplifiers do not need any special maintenance.
Should the unit become dirty, wipe the unit with a slightly damp cloth. Do not use solvent
or heavy cleaning agents.
Trouble-shooting
If the loop amplifier does not perform satisfactory, check the following:
• First make sure that your hearing instrument is in T-position and that mains power is
connected to the loop amplifier.
• Is the “Active indicator” lit? If not, is the audio source connected and transmitting
a signal? If the audio source is connected and transmitting a signal and the “active
indicator” is still not lit, the amplifier is not working properly and you may proceed to
the Service section of this manual.
• If the “Active indicator” is lit, but you still can not receive a signal in your hearing
instrument, the loop pad/sofa loop/loop wire is either not connected or faulty. Make
sure that it is connected properly.
