universalblue UELLABLACK4200-19, Instruction Manual

Page: 15 / 21

15
3. INSTALLATION
THE APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE SAFETY
STANDARDS OF YOUR MUNICIPALITY
Notes

Before assembling, be sure to remove all packing and protective material.

After removing the device from its packaging, check if it is damaged. If you are
unsure, do not use the appliance and contact qualified personnel.
To assemble your device, please follow the above detailed drawings together with the
following instructions:
1.
Insert the rear base plate into the slot as shown (figure 2).
2. Screw on the parts with the supplied screws (figure 3).
3. Mount the rear guard on the front casing (figure 4)
Note: When the appliance is switched on for the first time or when it is switched on
after long period disconnected, it is normal to emit a bit of odour and even smoke.
Please do not be worried, as this will disappear when the stove is in use for a short
period of time.
Before putting the device into operation, select a suitable place for the device, taking
into account the above safety instructions.
This device requires no installation and can be used as a portable device. Please
remember that this appliance is not intended for use in the bathroom.
4. GAS CHECKS AND LEAKAGE CONTROL
Before using the device, it is important that you consider the notes below:

The appliance may only be used with butane gas bottles of less than 15 kg.

The regulator must be approved according to EN16129 and the hose must be
approved according to EN16436-1 The hose must be less than 50 cm long.

Connect one end of the hose to the pressure regulator and the other end of the
hose to the faucet. Make sure connections are tight and there is no damage to
any components or accessories.

Before connecting the bottle, make sure that the tap is closed and that there are
no open flames nearby (oven on, etc.). Also, the gasket seal should be in good
condition. Then screw the pressure regulator onto the cylinder.

Connect the regulator to the tap and tighten the nut firmly counterclockwise.

Carefully check that there are no gas leaks in the soapy water connection (one
part detergent and three parts water). If there is a leak, bubbles will form; tighten
the connection further or seek qualified service or authorization from the
supplier.