13
ADJUSTING THE INK ROLL ECCENTRIC
As soon as you can see complete ink coverage on the die faces, stop rotating the eccentric. Proper adjustment
will normally be reached when the reference line on the Eccentric is somewhere between the 2 and 3 dial
position.
This adjustment procedure brings the Ink Roller into contact with the surface of the Transfer Roller which in turn
applies the ink to the face of the printing dies. Do not rotate the Ink Roll Eccentric Knob further than necessary
towards the “MAX” position or the excess contact pressure will squeeze ink out of the ink roll and may cause
dripping inside the cover.
FOR MOUNTING INSTRUCTIONS
REFER TO THE APPROPRIATE SECTION
FOR YOUR APPLICATION
WEB PRINTING - PAGE 17
CARTON PRINTING - PAGE 21
With the printing dies installed on the print drum, manu-
ally rotate the print drum continuously in one direction
while slowly rotating the Ink Roll Eccentric Adjusting Knob
“A” from the “MIN” towards the “MAX” position. Turn the
Eccentric Knob in small increments and observe the face
of the printing dies “I” for signs of ink between each ad-
justment.
FIGURE 22
QUICK START
Summary of Contents for MC-10 Series
Page 34: ......
