4: Setting up the Echo Remote:
•
The Echo Remote needs to be taught directly to the Active Unit (
MiniGAP (OMG)
Unit,
Basic Access
(OMG2)
Unit, or
Push-To-Exit
(OPE)
Unit)
•
To put the Echo Remote in Learn Mode, press the
large
button, button
2
and button
4
at the same time, for
1 second
and
release
.
•
On the OMG, OMG2, or OPE, press and release the black learn button located inside the unit on the circuit
board.
-
The remote will give an acceptance beep indicating success.
-
Proceed to
Step 6
.
!
Clearing the Memory
If you get an error tone at any time or need to re-teach a unit, you will need to clear the memory.
•
To clear the memory on an Ultra RX 900, hold down the learn button, located on the inside of the unit, until
the LED gives blinks 4 times, twice.
•
To clear the memory on a GCU, hold down the learn button until the LED gives 4 double blinks.
•
To clear the memory on a MiniGAP, Basic Access or Push-To-Exit, hold down the learn button until you
hear a low tone.
•
To clear the memory on an Echo Remote, press the
large
button, button
2
and button
4
at the same time
until you hear a beep.
General Operation
5: Using the Echo Remote with the ULTRX900-R in receiver mode:
•
Once the Echo Remote has been taught to the Ultra RX 900 unit, the buttons will automatically operate as follows:
Large Button – Activates Relay #1
Button #2 – Activates Relay #2
Button #3 – Activates Output 3
Button #4 – Activates Output 4
See the ULTRX900-R Instruction manual for more detailed instructions.
6: Using the Echo Remote with an Active Unit:
•
Once the Echo Remote has been taught to a GAP, Keypad, MiniGAP, Basic Access, Push-To-Exit, or DFGCU, the
buttons will automatically operate as follows:
Large Button – Activates GCU #1
Button #2 – Activates GCU #2
Button #3 – Activates GCU #3
Button #4 – Activates GCU #4
Note: If the Echo Remote has activated GCU 2, 3, or 4, and one of those GCU’s is removed from the network, the
corresponding button, if pressed, will give a 6 tone error signal.
If there is only 1 GCU, then buttons 2, 3, & 4, will do nothing.
FCC STATEMENT
This device complies with part 15 of the FCC Rules.
Part 15.21
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate
the equipment.
International Electronics, Inc.
FCC ID: JLFEC1
Country Of Origin: USA
Warranty
: This product is warranted to be free of defects for the period of
One Year
from the date of purchase.
The warranty covers parts, labor, and return
shipping to you, but not all accessories
. IEI will repair or replace any defective product at our discretion. Warranty does not cover misuse or damage other than due to
normal operating conditions. If you need to send the system to IEI for repair, contact IEI for a
Return Authorization number via email: [email protected].
Packages without a Return Authorization number will be rejected.
Universal Wireless Solutions
Designed and Manufactured In the USA.
A manufacturer’s full One Year Warranty covers this product
.
See www.WirelessGateAccess.com for technical information and questions
3
