Universal
Walk-In Bathtubs
5701 NW 35 Avenue Miami, FL 33142 PHONE: 877-360-4454 FAX: 866-560-1060 www.universaltubs.com
Page 17
OPERATING INSTRUCTIONS
OPERA
TING
INSTRUCTIONS
Universal
Walk-In Bathtubs
5701 NW 35 Avenue Miami, FL 33142 PHONE: 877-360-4454 FAX: 866-560-1060 www.universaltubs.com
Page 16
OPERATING INSTRUCTIONS
OPERA
TING
INSTRUCTIONS
Universal
Tubs
tm
Universal
Tubs
tm
operatIng InstructIons
When entering an Universal walk-in tub, be sure to close the door, placing the
handle
in the
down position
. Before activating any of the jetting controls, you
must first fill the bath to a water level at least 2 inches above the highest jet
placement. Do not put weight on the door when entering and exiting the tub.
It is recommended to leave the door in the open position when the tub is not
in use.
The pump is operated by the
hydro control button
, which starts the water flow.
The blower is operated by the
air control button
which starts the air flow (see
page 18).
Adjust the direction and rate of flow of the jets by moving the nozzle for direction. Turn either the outside ring or the nozzle clockwise
or counterclockwise for flow (some jets adjust the flow with the outside ring and some with the nozzle). Adjust the air pressure flow
of all water jets by using the
air volume control
(see page 18), which controls air-water mixture.
Universal walk-in tubs equipped with the chromotherapy lights
(ordered separately)
, feature a dedicated on/off switch. Pressing the
switch off and back on will change the color of light (see page 18).
purge cYcle
All air blowers are equipped with a purge cycle to remove residual water from the lines. The cycle will begin approximately 30
minutes after the unit is turned off and will continue for 1 - 2 minutes.
WarnIng:
Do not pusH tHe Button once tHe cYcle BegIns. DoIng so WIll cause
exaMple tuB Door HanDle
tHe BloWer to restart once tHe purge cYcle enDs.
In-lIne Heaters
If your bathtub is equipped with an in-line heater, it will operate only when the pump is on.
note: tHe In-lIne Heater Is DesIgneD to Keep Your Water WarMer longer, But Is not DesIgneD to Increase
tHe Water teMperature. Heat settIngs are not aDJustaBle.