FLORIDA-PNEUMATIC.COM
Please contact 1-800-356-3392 for further assistance.
Operation
1
Operating the screwdriver
□
This Screwdriver is designed to operate on 90 PSIG.
Lower pressure (below 90 PSIG) will reduce performance
of the tool. Higher air pressure (over 90 PSIG) raises the
performance of the tool beyond its rated capacity and
could cause serious damage to the tool and the user.
2
Changing the rotation direction
□
The direction of the bit rotation is reversible.
□
Control the rotation direction by moving the top-mounted
switch to F (forward) or R (reverse) as required for the
operation.
3
Installing and removing the bits
WARNING:
Disconnect the tool from the air supply before
servicing or changing accessories.
To install the bits:
□
Remove the air supply
from the screwdriver.
□
Pull ball retainer forward and insert the bit as
far as possible into the opening. Release retainer and ball
will lock into bit detent.
To remove the bits:
□
Remove the air supply from the screwdriver.
□
Pull ball retainer forward and remove the bit.
4
Clutch adjustment
5
Driving or removing screws
□
Place the rotation direction switch in the correct position
(forward or reverse) for the operation.
□
Hold the screwdriver with one hand.
□
Place the bit on the screw head and depress the trigger.
Start the bit slowly for more control.
□
Clutches are adjusted through the slot
provided in the clutch housing. The
slot cover must be rotated to expose
the adjustment slot. Rotate the clutch
housing (ref 58) until the hole in the
adjustment nut is visible.
□
Insert screwdriver and rotate in a clockwise direction to
increase torque or in a counter-clockwise direction to
decrease the torque.
□
After each adjustment, the slot cover should be rotated back
into its locked position.
