FLORIDA-PNEUMATIC.COM
Please contact 1-800-356-3392 for further assistance.
Operation
1
Operating the vertical grinder
□
This Vertical Grinder is designed to operate on 90 PSIG.
Lower pressure (below 90 PSIG) will reduce performance
of the tool. Higher air pressure (over 90 PSIG) raises the
performance of the tool beyond its rated capacity and
could cause serious damage to the tool and the user.
□
This tool features a safety lock-off mechanism.
2
Installing the grinding wheel
WARNING:
Disconnect the tool from the air supply before
servicing or changing accessories.
3
Grinding and deburring
4
□
Connect the grinder to the air supply.
□
This tool features a safety lock-off mechanism.
□
Operate the tool by disengaging the safety lock-off
mechanism and depressing the throttle lever to run the tool
for grinding or deburring.
WARNING:
You must wear the ANSI approved eye
protection during the operation; failure to follow this this may
result in serious injury or damage to the operator.
WARNING:
The rear wheel mounting flange must be
removed from the grinder before use.
Once the threaded hub wheel is fitted it must be securely
tightened by holding the spindle of the grinder with the
wrench provided, while tightening the wheel clockwise with
a second wrench placed on the hexagon section at the rear
face of the wheel. It is also recommended that for the first
operation after fitting the wheelthat the wheel is held firmly
on the work surface prior to starting the grinder.
WARNING:
Hearing protection is strongly recommended. A
protective respirator is recommended.
□
Remove the flange nut with the
spanner wrench.
□
Mount the grinding wheel onto
the spindle.
□
Replace the flange nut and
tighten using the hex key.
