11
Back panel of the Access Point:
Power Socket
The power adapter plugs into the socket labeled “POWER”.
Ethernet Ports ( WAN port )
The Wireless LAN Access Point supports an Ethernet ports: RJ-45
MDI daisy-chain port (labeled “MDI”). You may connect the Access Point
either to a hub or a PC. Please note that, use the cross-over cable when you
desire to connect the Access Point to a PC. The two LEDs (10/100/Link)
next to the Ethernet ports indicate the Ethernet physical link status. The
‘Link’ LED is a good indicator for to see if you have proper Ethernet
connection.
Reload
NOTE:
The button labeled “Reload” enables you to restore the Access Point’s
default setting. This is used when you forget the password. Please detach the
DC power plug and press the “
Reload
” button on the back panel of the Access
Point. Reconnect the power and keep holding the button in for a few seconds
until the “
AP
” LED indicator blinks. This will restore the Access Point’s default
settings and enable you to configure the Access Point via utility, telnet or Web
again.
Summary of Contents for AP-AG-AT-01
Page 7: ...7...
Page 16: ...16 3 3 Using the Telnet...
