![background image](http://html1.mh-extra.com/html/universal-remote-control/unifier-urc-100/unifier-urc-100_owners-manual_1058976007.webp)
Basic Setup
You can start setting up your Unifier using either the
Pre-Programmed Method or the Learning Method.
However, all the buttons of the Unifier are setup at once
with the Pre-Programmed Method, so it is usually faster
than the one-button-at-a-time Learning Method.
Pre-Programmed Method
Power on the A/V component you wish to setup, so that
you can test codes by sending power off commands.
Refer to the pre-programmed code tables on pages
25 - 46 and write down the code numbers listed
for your A/V component. The code numbers are
listed by categories of devices, then by brand. See
page 25 for a category list.
Press and hold both the SHIFT and ENT (Enter)
buttons for approximately three seconds. The top of
the display will blink “SET” then one of the eight
device names. You are in SETUP mode now.
Note:
You have 30 seconds to perform a step while you are
in SETUP mode. If you don’t press a button within that time,
the Unifier will time out and return to normal operation.
5
U R C - 1 0 0
SHIFT
Button
ENT
Button
1
2
3
Summary of Contents for Unifier URC-100
Page 1: ...Owner s Manual...
Page 5: ...Button Layout 3 U R C 1 0 0 LIGHT Button SHIFT Button FUNCTION Buttons DISPLAY DEVICE Buttons...
Page 53: ...OCE 0023A Rev 04...
Page 54: ......