System configuration for External LAN network
One DMS component must connect to your broadband router using a standard
①
ROUTER
PC
Ethernet cable(supplied). Follow the steps below to connect a DMS-1200. if you plan to
connect to an external amplifier or to powered speakers, you can connect a zone
amplifier DMS-100 instead.
Connect an Ethernet cable from any of the Ethernet switch connectors on the back of
your zone amplifier to open port on your router.
z
Do not connect the zone amplifier directly to your cable or DSL modem has a built-in
t
①
S/W(MFS-8)
LAN ③
LAN ②
router.
z
If you don`t have a router, go to
http://www.universalremote.com
for instructions.
① Connect Ethernet cable to LAN jack on the back panel of the ROUTER unit.
② Connect computer cable to distribution jack on the back panel of the ROUTER unit.
③ Connect switcher cable to another distribution jack on the back panel of the
ROUTER unit.
④ Connect multi-zone amplifier cable to another distribution jack on the back panel of
DMS-1200
LAN
Multi-zone amplifier
LAN ④
④ Connect multi-zone amplifier cable to another distribution jack on the back panel of
the ROUTER unit.
System configuration for Internal LAN network
One DMS component must connect to your broadband router using a standard
Ethernet cable(supplied) Follow the steps below to connect a DMS 1200 if you plan to
MP3
player
Ethernet cable(supplied). Follow the steps below to connect a DMS-1200. if you plan to
connect to an external amplifier or to powered speakers, you can connect a zone
amplifier DMS-100 instead.
Connect an Ethernet cable from the Ethernet connectors on the back of your DMS-
1200 multi-zone amplifier to open port on your computer.
① Connect Ethernet cable to LAN jack on the back panel of the DMS-1200 and
Connect LAN cable to the COMPUTER unit.
PC
DVD player
DMS-1200
Connect LAN cable to the COMPUTER unit.
② Connect EXTernal cable to signal source jack on the back panel of the audio
equipment or player unit and connect multi-zone amplifier cable to another audio
equipment or DVD player.
③ From computer you can control or adjust for audio control program
Select audio INPUT source and OUTPUT zone, MAC address etc. this function
can be select input source channel and INPUT gain level and data send to audio
LAN
LAN①
cable③
equipment.
After choice output zone you can adjust zone limit power rate and zone power
ON/OFF and source signal INPUT channel.
You can adjust amplifier volume level per each zone for proper sound output
and Maximum limitation volume level.
You can set turn on ramp up volume level and adjust Equalizer repetory and
LVLC(L V l
L d
C t l) ff ti
d
t
E
li
li
LVLC(LowVolumeLoudnessControl) effectiveness and custom Equalizer align.
④
Also factory reset initialize and MAC address pick it up from AP(access point) and source program
up and down load.
