INSTRUCTION SHEET
507964
Stacking Media Console
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution:
(1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Console
1pc
B
Foot
6pcs
C
Center support leg
1pc
D
Leg Hardware pack
1bag
E
Hardware pack
1bag
Assembly Procedure
: (Please follow the sketches below.)
Step 1:
Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2:
Attach the feet (B) to the console (A) with allen head bolt (1), spring washer (2) and flat
washer (3) using allen wrench (4) from leg hardware pack (D).
Step 3
: Disregard this step when the upper console is not in use. Put the square foam pads (7) onto
the lower console as below shown. Then attach the upper console (without feet) to the lower
console and lock it with mending plate (5) and screws (6) from backside.
Note:
It is best two or more persons are involved.
Assembly is now complete.
Q'TY
HARDWARE LIST (D)
12PCS
SQUARE
FORM PAD
SCREW
2PCS
MENDING
PLATE
8PCS
Q'TY
HARDWARE LIST (E)
4PCS
FLAT
WASHER
SPRING
WASHER
1PC
12PCS
ALLEN
HEAD BOLT
ALLEN
WRENCH
12PCS
