GOOD, AFFORDABLE, SMART DESIGN.
INSTRUCTION SHEET
356801 COCKTAIL
TABLE
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution:
(1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
Qty. # Description
Qty.
A
Table Top
1 pc
E
Hardware Pack
1set
B
Leg
4 pcs
C
Metal Stretcher
1 pc
D
Foot
4 pcs
Assembly Procedure
: (Please follow the sketches below.)
Step 1:
Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2:
Place the Table Top (A) upside down in a smooth, clean, and soft surface, and then attach
the leg ( B ) to the table top ( A ) with the flat head bolt ( 1 ), spring washer ( 2 ) and flat
washer ( 3 ), please tighten the bolts with the allen wrencn (4) provided for this step.
Step 3:
Put the metal stretcher ( C ) onto the leg ( B ) and then fix the foot ( D ) into the leg ( B ),
please tighten the foot for this step.
Turn the table upright and now assembly is complete.
