www.urcsupport.com
14
CHECKING THE CODES
If you have set up the Polaris Remote Control by
searching for your device code (on the previous page),
you may need to find out which four-digit code is
operating your equipment. To find out which code is
operating your TV:
PROGRAMMING ID LOCK
The Polaris Remote Control is locked at the factory to
operate your cable system’s cable converter. However, if
you have another brand or model of cable converter that
you would like to control, then you’ll need to perform the
following steps to unlock the ID Lock, enter a new
manufacturer’s code, and lock the ID Lock again.
1.
On the remote control, press
TV
once; it blinks
once. Then press and hold
SETUP
until the
TV
key blinks twice.
2.
Enter
9 9 0
. The
TV
key blinks twice.
3.
To view the code for the first digit, press
1
once. Count the number of times the
TV
key
blinks (e.g., 3 blinks = 3) and write down the
number in the leftmost TV Code box on
page 13.
NOTE:
If a code digit is 0, the selected mode key does
not blink.
4.
Repeat step 3 three more times for the
remaining digits. Use
2
for the second digit,
3
for the third digit, and
4
for the fourth digit.
Finish writing down the code in the TV Code
boxes on page 13.
