CHECKING THE CODES
If you have set up the Millennium 4 using the
Searching
For Your Code
procedure, you may need to find out which
four-digit code is operating your equipment:
For example, to find out which code is operating your TV:
1.
Turn on your TV.
2.
On the Millennium 4, press and hold
SETUP
until the LED blinks twice, then release
SETUP
.
3.
Enter
9
-
9
-
0
. The LED will blink twice.
4.
To view the code for the first digit, press
1
once.
Wait 3 seconds and count the number of LED
blinks (e.g., 3 blinks = 3) and write down the
number in the leftmost TV Code box below.
NOTE: If a code digit is “0”, the LED will not blink.
5.
Repeat step 4 three more times for remaining
digits. Use
2
for the second digit,
3
for the third
digit, and
4
for the fourth digit. Finish writing
down the code in the TV Code boxes below.
6.
To check for the codes of your other compo-
nents, repeat steps 1 through 5, but substitute
the appropriate key (i.e.,
VCR
,
CBL
, or
AUDIO
)
for the (VCR, Cable, or Audio) component you
are checking.Write down the codes in the
appropriate boxes below.
TV Code
VCR Code
CABLE Code
AUDIO
___________________
Code
27
Millennium 4 Mnl M4090 7/23/99 9:34 AM Page 27
